84490D
1.INSPECT IPA MAIN SWITCH ASSEMBLY
Check the resistance.
| *a | Component without harness connected
(IPA Main Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 6 (IG) - 3 (E) | IPA main switch assembly pressed | Below 1 Ω |
| 6 (IG) - 3 (E) | IPA main switch assembly not pressed | 10 kΩ or higher |
If the result is not as specified, replace the IPA main switch assembly.
Check that the switch illuminates.
| *a | Component without harness connected
(IPA Main Switch Assembly) |
Apply battery voltage to the IPA main switch assembly and check that the switch illuminates.
| Connection | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 5 (ILL+)
Battery negative (-) → Terminal 4 (ILL-) |
Illuminates |
If the result is not as specified, replace the IPA main switch assembly.