Home › Vehicle Exterior › WIPER / WASHER › REAR WIPER MOTOR
RM32K0E _59 Vehicle Exterior _061789 WIPER / WASHER _0304154 REAR WIPER MOTOR G

WIPER / WASHER  REAR WIPER MOTOR  INSPECTION  


PROCEDURE

Hide 85110R 1.INSPECT REAR WIPER MOTOR ASSEMBLY

E239384C24
1.281,1.25 1,1.75 true 1.5,1.25 1.417,1.75 true 1.75,1.25 1.865,1.75 true 0.104,0.063 0.26,0.24 0.156,0.177 10 false *a 1.302,1.76 1.583,1.938 0.281,0.177 10 false +B 1.813,1.76 2.135,1.938 0.323,0.177 10 false LS 0.958,1.76 1.156,1.948 0.198,0.188 10 false E
*a Component without harness connected
(Rear Wiper Motor Assembly)


a.

Check that the rear wiper motor assembly operates.

NOTICE:

Check that the body ground is connected.


i.

Apply battery voltage to the rear wiper motor connector and check the speed of the rear wiper motor assembly.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 4 (+B)
Battery negative (-) → Terminal 3 (LS)
Battery negative (-) → Terminal 5 (E)
Motor operates


If the result is not as specified, replace the rear wiper motor assembly.



b.
E239384C25
1.271,1.25 0.938,1.75 true 1.5,1.25 1.333,1.75 true 1.958,1.25 2.24,1.75 true 0.104,0.063 0.26,0.24 0.156,0.177 10 false *a 1.25,1.76 1.531,1.938 0.281,0.177 10 false +B 2.188,1.76 2.573,1.938 0.385,0.177 10 false C1 0.885,1.76 1.083,1.948 0.198,0.188 10 false E
*a Component without harness connected
(Rear Wiper Motor Assembly)


Check the wiper intermittent operation.

NOTICE:

Check that the body ground is connected.


i.

Apply battery voltage to the rear wiper motor connector and check the speed of the rear wiper motor assembly.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 4 (+B)
Battery negative (-) → Terminal 2 (C1)
Battery negative (-) → Terminal 5 (E)
Motor operates


If the result is not as specified, replace the rear wiper motor assembly.