Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR
RM32K0E _59 Vehicle Exterior _061789 WIPER / WASHER _0304158 WASHER MOTOR G

WIPER / WASHER  WASHER MOTOR  INSPECTION  


PROCEDURE

Hide 85310 1.INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY (for Front Side)

HINT:

This check should be performed with the windshield washer motor and pump assembly installed to the windshield washer jar assembly.


a.

Fill the windshield washer jar assembly with washer fluid.


b.
E285976C01
1.917,1.073 2.135,0.771 true 1.313,1.135 1.073,0.781 true 0.063,0.063 0.375,0.219 0.313,0.156 10 false *a 2.156,0.646 2.313,0.844 0.156,0.198 10 false + 1.031,0.625 1.188,0.823 0.156,0.198 10 false -
*a Component without harness connected (Windshield Washer Motor and Pump Assembly)


Check that washer fluid flows from the windshield washer jar assembly.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 2 (+)
Battery negative (-) → Terminal 1 (-)
Washer fluid flows from the windshield washer jar assembly


If the result is not as specified, replace the windshield washer motor and pump assembly.


Hide 85310 2.INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY (for Rear Side)

HINT:

This check should be performed with the windshield washer motor and pump assembly installed to the windshield washer jar assembly.


a.

Fill the windshield washer jar assembly with washer fluid.


b.
E285976C02
1.354,1.073 1.083,0.823 false 1.854,1.083 2.094,0.813 false 0.063,0.073 0.375,0.229 0.313,0.156 10 false *a 2.115,0.646 2.271,0.844 0.156,0.198 10 false - 1,0.677 1.156,0.875 0.156,0.198 10 false +
*a Component without harness connected (Windshield Washer Motor and Pump Assembly)


Check that washer fluid flows from the windshield washer jar assembly.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 1 (+)
Battery negative (-) → Terminal 2 (-)
Washer fluid flows from the windshield washer jar assembly


If the result is not as specified, replace the windshield washer motor and pump assembly.