85035
1.INSPECT WASHER NOZZLE SUB-ASSEMBLY
Operate the washer nozzle sub-assemblies and check the position that the washer fluid contacts the windshield.
Washer fluid contacts the windshield in the areas shown in the illustration.
| *a | Upper Limit | *b | Standard |
| *c | Lower Limit | - | - |
|
Measurement | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 341.0 mm (13.43 in.) | B | 187.0 mm (7.36 in.) |
| C | 82.5 mm (3.25 in.) | - | - |
If the result is not as specified, replace the washer nozzle sub-assembly.