85035
1.REMOVE WASHER NOZZLE SUB-ASSEMBLY
Use the same procedure as for the opposite side.
| *a | Protective Tape |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Using a screwdriver with its tip wrapped in protective tape, disengage the claws as indicated by the arrows, shown in the illustration to separate the washer nozzle sub-assembly.
Be careful not to damage the windshield glass.
Disconnect the washer hose to remove the washer nozzle sub-assembly.
Washer nozzle sub-assemblies cannot be reused.