Home › Vehicle Exterior › WIPER / WASHER › WASHER LEVEL WARNING SWITCH
RM32K0E _59 Vehicle Exterior _061789 WIPER / WASHER _0304161 WASHER LEVEL WARNING SWITCH G

WIPER / WASHER  WASHER LEVEL WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT LEVEL WARNING SWITCH

HINT:

This check should be performed with the level warning switch installed on the washer jar.


a.
E158668C24
1.969,1.365 2.531,1.615 true 1.375,1.333 0.865,1.615 true 2.615,1.563 2.75,1.74 0.135,0.177 10 false S 0.74,1.573 0.875,1.75 0.135,0.177 10 false E 0.208,0.135 0.469,0.313 0.26,0.177 10 false *a
*a Component without harness connected
(Level Warning Switch)


Fill the washer jar with washer fluid.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (S) - 2 (E) Fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) or higher* 10 kΩ or higher
Fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) or lower* Below 1 Ω


HINT:

*: The level warning switch begins operating when the fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) depending on the vehicle condition.


If the result is not as specified, replace the level warning switch.