Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER CONTROL RELAY
RM32K0E _59 Vehicle Exterior _061789 WIPER / WASHER _0304164 HEADLIGHT CLEANER CONTROL RELAY G

WIPER / WASHER  HEADLIGHT CLEANER CONTROL RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85942 1.INSPECT HEADLIGHT CLEANER CONTROL RELAY (for LED Headlight)

a.

Check the operation of the Headlight cleaner control relay connector.


b.
E303137C04
1.667,0.917 1.833,0.417 true 1.417,0.917 1.25,0.417 true 1.25,1.667 1.417,1.219 true 2.083,1.667 1.969,1.24 true 1.167,0.229 1.479,0.427 0.313,0.198 10 false IG 1.823,0.229 2.135,0.427 0.313,0.198 10 false H 1.135,1.708 1.448,1.906 0.313,0.198 10 false PB 2.083,1.708 2.396,1.906 0.313,0.198 10 false E 0.167,0.167 0.479,0.365 0.313,0.198 10 false *a
*a Component without harness connected
(Headlight Cleaner Control Relay)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (PB) - 4 (E) Battery voltage applied between terminals 3 (IG) and 2 (H) Below 1 Ω
Battery voltage not applied between terminals 3 (IG) and 2 (H) 10 kΩ or higher


If the result is not as specified, replace the headlight cleaner control relay.