1.INSTALL REAR BUMPER ASSEMBLY
|
Install in the Direction |
Connect the connector.
Engage the claws as shown in the illustration.
|
Install in the Direction |
Engage the claws as shown in the illustration.
Use the same procedure for the RH side and LH side.
Install the bolt.
Use the same procedure for the RH side and LH side.
Install the rear bumper upper cover LH.
Use the same procedure as for the LH side.
Install the rear bumper assembly with the 4 clips.
75652
2.INSTALL QUARTER OUTSIDE MOULDING LH
Engage the claws to install the quarter outside moulding LH.
Install the 2 screws.
75651
3.INSTALL QUARTER OUTSIDE MOULDING RH
Use the same procedure as for the LH side.
52592
4.INSTALL REAR BUMPER SIDE SEAL LH
Install the rear bumper side seal LH with the 6 clips.
52591
5.INSTALL REAR BUMPER SIDE SEAL RH
Use the same procedure as for the LH side.