Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROCKER PANEL MOULDING
RM32K0E _59 Vehicle Exterior _061792 EXTERIOR PANELS / TRIM _0304180 ROCKER PANEL MOULDING A

EXTERIOR PANELS / TRIM  ROCKER PANEL MOULDING  REASSEMBLY  


PROCEDURE

Hide 75861C 1.INSTALL ROCKER PANEL MOULDING PAD

HINT:
·

Using the same procedure, remove every rocker panel moulding pad.

·

When installing the rocker panel moulding pad, heat the rocker panel moulding using a heat light.



Heating Temperature:
Item Temperature
Rocker Panel Moulding 20 to 30°C (68 to 86)


CAUTION:
·
E306500C35
2.365,2 2.698,2 false 0.5,2.333 0.5,2.667 true 0.427,2.708 0.74,2.865 0.313,0.156 10 false *a 2.76,1.927 3.073,2.083 0.313,0.156 10 false *b
*a Heated Part
*b Heat Light


Do not touch the heat light and heated parts, touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.



NOTICE:

Do not heat the rocker panel moulding excessively.


a.

Clean the rocker panel moulding surface.

i.

Using a heat light, heat the rocker panel moulding surface.


ii.

Remove the double-sided tape from the rocker panel moulding.


iii.

Wipe off any tape adhesive residue with cleaner.



b.

Using a heat light, heat the rocker panel moulding.


c.

Remove the release paper from a new rocker panel moulding pad.

HINT:

After removing the release paper, keep the exposed adhesive free from foreign matter.



d.
B458861C01
2.073,0.76 2.49,0.344 true 2.521,0.198 2.833,0.396 0.313,0.198 10 false *a
*a Line


Install the rocker panel moulding pads.

HINT:

Install a rocker panel moulding pad along the line on the rocker panel moulding.