Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › WHEEL OPENING MOULDING (for Front)
RM32K0E _59 Vehicle Exterior _061792 EXTERIOR PANELS / TRIM _0304187 WHEEL OPENING MOULDING(for Front) A

EXTERIOR PANELS / TRIM  WHEEL OPENING MOULDING(for Front)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 75602A 1.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY

a.

Remove the 3 clips and 5 screws.

B465605


b.
B458749C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the front fender moulding sub-assembly.


c.
B465602C01
0.417,0.76 0.885,1.031 true 2.5,0.708 2.708,0.885 0.208,0.177 10 true *a 0.229,0.667 0.438,0.844 0.208,0.177 10 false *1
*1 Pin Hold Clip
*a 90 deg


Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.

HINT:

Use the same procedure for the RH side and LH side.



d.
B465628C01
0,0 0,0 false
V113146

Place Hand Here
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Pull back the edge of the front fender liner and disengage the claws by pushing the area indicated by the arrow in the illustration with a finger.

NOTICE:
·

Do not apply excessive force when pulling back the front fender liner.

·

To avoid damaging the claws, do not forcibly pull the front fender moulding sub-assembly.




e.
B458751C01
0,0 0,0 false
V113146

Place Hand Here
V113147

Remove in this Direction


Disengage the clips to remove the front fender moulding sub-assembly as shown in the illustration.