Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › WHEEL OPENING MOULDING(for Rear)
RM32K0E _59 Vehicle Exterior _061792 EXTERIOR PANELS / TRIM _0304188 WHEEL OPENING MOULDING(for Rear) A

EXTERIOR PANELS / TRIM  WHEEL OPENING MOULDING(for Rear)  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 75696 1.REMOVE NO. 1 BODY OUTSIDE MOULDING PAD

a.
B458759

Remove the No. 1 body outside moulding pad (double-sided tape).

HINT:
B384421

Do not pull on No. 1 body outside moulding pad (double-sided tape). Instead, roll the tape up with your finger to remove it cleanly.



b.

Using non-residue solvent and a cloth, wipe off any No. 1 body outside moulding pad (double-sided tape) remaining on the quarter outside moulding.