Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › WHEEL OPENING MOULDING(for Rear)
RM32K0E _59 Vehicle Exterior _061792 EXTERIOR PANELS / TRIM _0304188 WHEEL OPENING MOULDING(for Rear) A

EXTERIOR PANELS / TRIM  WHEEL OPENING MOULDING(for Rear)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 75652 1.INSTALL QUARTER OUTSIDE MOULDING

HINT:

When installing the quarter outside moulding, heat the vehicle body and quarter outside moulding using a heat light.


CAUTION:
·
E306500C35
2.365,2 2.698,2 false 0.5,2.333 0.5,2.667 true 0.427,2.708 0.74,2.865 0.313,0.156 10 false *a 2.76,1.927 3.073,2.083 0.313,0.156 10 false *b
*a Heated Part
*b Heat Light


Do not touch the heat light and heated parts, touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.



Standard:
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Quarter Outside Moulding 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the vehicle body and quarter outside moulding excessively.


a.

Clean the vehicle body surface.

i.

Using a heat light, heat the vehicle body surface.


ii.

Remove any double-sided tape from the vehicle body.


iii.

Wipe off any tape adhesive residue with cleaner.



b.

Remove the release paper from a new quarter outside moulding.

HINT:

After removing the release paper, keep the exposed adhesive free from foreign matter.



c.

Engage the clips and attach the double-sided tape.

B465630C03
6.24,2 4.865,1.281 true 6.333,1.938 6.646,2.135 0.313,0.198 10 false *a
*a Double-sided Tape - -
V113147

Install in this Direction - -


HINT:

Press the quarter outside moulding to install it.



d.

Engage the claws.


e.

Install the 3 screws and clip.


f.

Remove the protective tape.