Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM MAIN SWITCH
RM32K0E _59 Vehicle Exterior _061162 LIGHTING (EXT) _0304281 AUTOMATIC HIGH BEAM MAIN SWITCH G

LIGHTING (EXT)  AUTOMATIC HIGH BEAM MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84153 1.INSPECT AUTO HIGH BEAM SWITCH

a.

Check the resistance.

i.
C335690C09
1.344,1.844 1.646,1.313 true 2.365,1.823 2.031,1.323 true 1.885,1.833 1.802,1.323 true 1,1.854 1.438,1.302 true 1.26,1.865 1.719,2.063 0.458,0.198 10 false ILL+ 2.281,1.875 2.74,2.073 0.458,0.198 10 false GND 0.083,0.083 0.375,0.281 0.292,0.198 10 false *a 0.854,1.875 1.313,2.073 0.458,0.198 10 false +B 1.844,1.875 2.302,2.073 0.458,0.198 10 false ILL-
*a Component without harness connected
(Auto High Beam Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
6 (+B) - 3 (GND) Auto high beam switch on Below 1 Ω
6 (+B) - 3 (GND) Auto high beam switch off 10 kΩ or higher


If the result is not as specified, replace the auto high beam switch.



b.

Check the illumination.

i.

Apply auxiliary battery voltage to the auto high beam switch and check that it illuminates.

OK:
Condition Specified Condition
Auxiliary battery positive (+) → Terminal 5 (ILL+)
Auxiliary battery negative (-) → Terminal 4 (ILL-)
Illuminates


If the result is not as specified, replace the auto high beam switch.