84340
1.INSPECT STOP LIGHT SWITCH ASSEMBLY
| *a | Front view of wire harness connector
(to Stop Light Switch Assembly) |
Disconnect the A45 stop light switch assembly connector.
Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A45-7 (B) - A45-2 (GND) | Power switch off | 11 to 14 V |
| A45-6 (B) - A45-2 (GND) | Power switch on | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A45-2 (GND) - Body ground | Always | Below 1 Ω |
If the result is not as specified, repair or replace the wire harness or connector.
| *a | Component with harness connected
(Stop Light Switch Assembly) |
Reconnect the A45 stop light switch assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A45- 1 (OUT) - A45-2 (GND) | Power switch off, brake pedal not depressed | Below 1 V |
| A45-1 (OUT) - A45-2 (GND) | Power switch off, brake pedal depressed | 11 to 14 V |
| A45-3 (L) - A45-2 (GND) | Power switch off, brake pedal not depressed | Below 1 V |
| A45-3 (L) - A45-2 (GND) | Power switch off, brake pedal depressed | 11 to 14 V |
| A45-4 (ACC) - A45-2 (GND) | Power switch off | 11 to 14 V |
| A45-5 (L) - A45-2 (GND) | Power switch on, brake pedal not depressed | 11 to 14 V |
| A45-5 (L) - A45-2 (GND) | Power switch on, brake pedal depressed | Below 1 V |
If the result is not as specified, replace the stop light switch assembly.