Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC LIGHT CONTROL SENSOR
RM32K0E _59 Vehicle Exterior _061162 LIGHTING (EXT) _0304283 AUTOMATIC LIGHT CONTROL SENSOR G

LIGHTING (EXT)  AUTOMATIC LIGHT CONTROL SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89120A 1.INSPECT AUTOMATIC LIGHT CONTROL SENSOR

a.

Check the wire harness.

i.

Disconnect the automatic light control sensor (G1).


ii.
B157083C57
1.521,0.333 1.896,0.552 0.375,0.219 1.135,1.625 1.438,1.198 true 1.646,1.698 1.625,1.198 true 0.135,0.104 0.344,0.26 0.208,0.156 10 false *a 1.625,0.375 1.865,0.583 0.24,0.208 10 false G1 0.948,1.656 1.354,1.823 0.406,0.167 10 false CLTB 1.479,1.729 1.885,1.896 0.406,0.167 10 false CLTE
*a Front view of wire harness connector
(Automatic Light Control Sensor)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
G1-1(CLTB) - G1-2(CLTE) Power switch on 11 to 14 V


If the specified condition is not met, replace the vehicle wire harness.



b.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
G1-2(CLTE) - Body ground Always Below 1 Ω


If the specified condition is not met, replace the vehicle wire harness.



c.

Check the automatic light control sensor.

i.

Connect the automatic light control sensor (G1).


ii.
E259758C68
1.531,0.271 1.927,0.49 0.396,0.219 1.479,1.26 1.271,1.698 true 1.823,1.281 2.125,1.656 true 0.188,0.135 0.438,0.313 0.25,0.177 10 false *a 1.646,0.302 1.844,0.458 0.198,0.156 10 false G1 1.073,1.75 1.49,1.927 0.417,0.177 10 false CLTS 2.01,1.708 2.427,1.906 0.417,0.198 10 false CLTE
*a Component with harness connected
(Automatic Light Control Sensor)


Check the waveform

Use the oscilloscope and check the waveform in the terminal spaces.

NOTICE:

With the connector connected as is, check from the rear side of the connector.


Standard:
Tester Connection Switch Condition Standard
G1-4(CLTS) - G1-2(CLTE) Power switch on, light control switch in AUTO position Correct waveform is as shown


If the specified condition is not met, replace the solar sensor.


iii.
E276298N04
2.844,1.667 3.302,1.865 0.458,0.198 10 false GND

Waveform

Item Content
Terminal G1-4(CLTS) - G1-2(CLTE)
Equipment Setting 2V/DIV.,10ms/DIV.
Condition Power switch on, head light dim switch in AUTO position

The communication waveform changes according to the surrounding brightness.