68960B
1.DISPOSE OF BACK DOOR STAY ASSEMBLY
Fully extend the back door stay assembly.
Secure the back door stay assembly horizontally in a vise with the piston rod pulled out.
Wearing protective glass, gradually cut the shaded part between "A" and "B" shown the illustration using a metal saw to gradually release the gas.
| Area | Measurement |
|---|---|
| A - B | 53.5 mm (2.11 in.) |
Always use proper safety equipment and be careful when drilling because shards of metal way fly about.
The gas is colorless, odorless and non-poisonous.