Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR SUPPORT
RM32K0E _59 Vehicle Exterior _061791 DOOR / HATCH _0304561 BACK DOOR SUPPORT A

DOOR / HATCH  BACK DOOR SUPPORT  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 68960B 1.REMOVE BACK DOOR STAY ASSEMBLY

CAUTION:
·
B450745

Do not perform work if the back door is not securely supported.

·

The back door could fall, resulting in injury.



NOTICE:
·

Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

·

Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

·

Do not apply any horizontal load to the door stay in order to prevent the piston rod from deforming.



a.
B450746C01
2.74,2.583 3.031,2.125 true 0.521,0.844 0.396,0.479 true 3.073,1.938 3.323,2.146 0.25,0.208 10 true *a 0.24,0.271 0.49,0.458 0.25,0.188 10 true *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, remove the 2 stop rings as shown in the illustration.


b.

Release the ball joint to remove the back door stay assembly.

NOTICE:
·

Remove the back door stay assembly while supporting the back door by hand.

·

Remove the back door stay assembly while supporting the back door stay assembly by hand.




Hide 68946 2.REMOVE BACK DOOR DAMPER STAY UPPER BRACKET

a.
B450747

Remove the 2 bolts and back door damper stay upper bracket.


Hide 68948 3.REMOVE BACK DOOR DAMPER STAY LOWER BRACKET

a.
B450748

Remove the 2 bolts and back door damper stay lower bracket.