Home › Vehicle Exterior › DOOR / HATCH › FUEL LID OPENER SWITCH
RM32K0E _59 Vehicle Exterior _061791 DOOR / HATCH _0304563 FUEL LID OPENER SWITCH G

DOOR / HATCH  FUEL LID OPENER SWITCH  INSPECTION  


PROCEDURE

Hide 84841A 1.INSPECT FUEL LID OPENER SWITCH (for LHD)

a.
B450758C01
2.073,2.802 2.198,3.146 true 1.573,2.792 1.125,3.167 true 2.229,3.188 2.49,3.385 0.26,0.198 10 false E 1.031,3.198 1.25,3.365 0.219,0.167 10 false IG 0.865,1.969 1.146,2.198 0.281,0.229 10 false *a
*a Component without harness connected
(Fuel Lid Opener Switch)


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
4 (IG) - 1 (E) Pressed (ON) Below 1 Ω
4 (IG) - 1 (E) Not pressed (OFF) 10 kΩ or higher


If the result is not as specified, replace the fuel lid opener switch.



b.
B450758C02
2.219,3.188 1.885,2.802 true 1.292,3.219 1.688,2.781 true 2.302,3.135 2.667,3.333 0.365,0.198 10 false ILL- 0.958,3.135 1.323,3.333 0.365,0.198 10 false ILL+ 0.885,2 1.25,2.198 0.365,0.198 10 false *a
*a Component without harness connected
(Fuel Lid Opener Switch)


Check that the LED illuminates.

i.

Apply auxiliary battery voltage to the fuel lid opener switch and check that the fuel lid opener switch illuminates.

OK:
Auxiliary battery Connection Specified Condition
Auxiliary battery positive (+) → 3 (ILL+) LED illuminates
Auxiliary battery negative (-) → 2 (ILL-)


If the result is not as specified, replace the fuel lid opener switch.



Hide 84841A 2.INSPECT FUEL LID OPENER SWITCH (for RHD)

a.
B465092C03
1.156,3.135 1.552,2.813 true 2.323,3.094 2.042,2.792 true 0.833,1.99 1.146,2.146 0.313,0.156 10 false *a 0.969,3.073 1.208,3.25 0.24,0.177 10 false IG 2.396,3.031 2.635,3.208 0.24,0.177 10 false E
*a Component without harness connected
(Fuel Lid Opener Switch)


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
4 (IG) - 1 (E) Pressed (ON) Below 1 Ω
4 (IG) - 1 (E) Not pressed (OFF) 10 kΩ or higher


If the result is not as specified, replace the fuel lid opener switch.



b.
B465092C04
1.49,3.125 1.677,2.792 true 2.146,3.146 1.927,2.802 true 0.833,1.99 1.146,2.146 0.313,0.156 10 false *a 2.146,3.198 2.76,3.396 0.615,0.198 10 false ILL- 1.271,3.167 1.885,3.365 0.615,0.198 10 false ILL+
*a Component without harness connected
(Fuel Lid Opener Switch)


Check that the LED illuminates.

i.

Apply auxiliary battery voltage to the fuel lid opener switch and check that the fuel lid opener switch illuminates.

OK:
Auxiliary battery Connection Specified Condition
Auxiliary battery positive (+) → 3 (ILL+) LED illuminates
Auxiliary battery negative (-) → 2 (ILL-)


If the result is not as specified, replace the fuel lid opener switch.