87961
1.INSPECT OUTER MIRROR LH
| *a | Component without harness connected
(Outer Mirror LH) |
Check the resistance.
Measure the resistance according the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 25°C (77°F) | 8.5 to 11.5 Ω |
If the result is not as specified, replace the outer mirror LH.
| *a | Component without harness connected
(Outer Mirror LH) |
Check the operation of the outer rear view mirror indicator. (w/ Blind Spot Monitor System)
Do not apply a voltage of more than 6 V.
Connect 4 new 1.5 V dry-cell batteries in series.
Apply 6 V battery voltage to the terminals of the connector, and check that the outer rear view mirror indicator comes on.
| Tester Connection | Specified Condition |
|---|---|
| 6 V battery positive (+) → Terminal 1
6 V battery negative (-) → Terminal 2 |
Outer rear view mirror indicator comes on |
If the result is not as specified, replace the outer mirror LH.
87931
2.INSPECT OUTER MIRROR RH
| *a | Component without harness connected
(Outer Mirror RH) |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 25°C (77°F) | 8.5 to 11.5 Ω |
If the result is not as specified, replace the outer mirror RH.
| *a | Component without harness connected
(Outer Mirror RH) |
Check the operation of the outer rear view mirror indicator. (w/ Blind Spot Monitor System)
Do not apply a voltage of more than 6 V.
Connect 4 new 1.5 V dry-cell batteries in series.
Apply 6 V battery voltage to the terminals of the connector, and check that the outer rear view mirror indicator comes on.
| Tester Connection | Specified Condition |
|---|---|
| 6 V battery positive (+) → Terminal 1
6 V battery negative (-) → Terminal 2 |
Outer rear view mirror indicator comes on |
If the result is not as specified, replace the outer mirror RH.