The hybrid vehicle control ECU illuminates the cruise control indicator by sending indicator output demand signals to the combination meter assembly via CAN communication. The cruise control indicator illuminates when the cruise control system is turned on using the cruise control main switch (ON/OFF button). If a malfunction is detected, the cruise control indicator turns off and a warning message is displayed. The cruise control indicator circuit uses CAN communication. If the cruise control indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.
Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Meter Display 1 | Multi-information display | OFF, 6 to 0 or All | - |
| Tester Display |
|---|
| Meter Display 1 |
| Result | Proceed to |
|---|---|
| The multi-information display in the combination meter assembly turns on or off according to the operation of the Active Test. | A |
| The multi-information display in the combination meter assembly does not turn on or off according to the operation of the Active Test. | B |
A
B
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Enter the following menus: Powertrain / Cruise Control / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Cruise Ready Main-CPU | Cruise control system standby condition | ON or OFF | Each time cruise control main switch (ON/OFF button) is pushed, ON or OFF changes | - |
| Cruise Ready Sub-CPU | Cruise control system standby condition | ON or OFF | Each time cruise control main switch (ON/OFF button) is pushed, ON or OFF changes | - |
| Cruise Indicator | Cruise control indicator status | ON or OFF | ON: Cruise control indicator illuminates
OFF: Cruise control indicator turns off |
- |
| Tester Display |
|---|
| Cruise Ready Main-CPU |
| Cruise Ready Sub-CPU |
| Cruise Indicator |
| Result | Proceed to |
|---|---|
| The cruise control indicator illuminates and turns off according to the operation of the cruise control main switch (ON/OFF button). | A |
| The cruise control indicator does not illuminate but the Data List item Cruise Indicator changes according to the operation of the cruise control main switch (ON/OFF button). | B |
| The cruise control indicator does not illuminate and the Data List item Cruise Indicator does not change according to the operation of the cruise control main switch (ON/OFF button). | C |
A
B
C