This DTC is stored when there is a malfunction in the hybrid vehicle control ECU.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P057504 | Cruise Control System Internal Failure | While the cruise control system is operating, the cruise control system control of vehicle speed is not canceled and approximately 0.4 seconds have elapsed after cruise cancel signal (STP signal) is input to the hybrid vehicle control ECU. | Hybrid vehicle control ECU |
| P057549 | Cruise Control Internal Electronic Failure | When the power switch is on (IG), STP signals input to the hybrid vehicle control ECU supervisory CPU and that input to the control ECU do not match for approximately 0.2 seconds or more. | Hybrid vehicle control ECU |
Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.
The hybrid vehicle control ECU receives signals from each sensor to control all functions of the cruise control system. When a malfunction is detected, the fail-safe function operates until the power switch is turned off.
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
Perform the following to make sure that the DTC detection conditions are met.
If the detection conditions are not met, the malfunction cannot be detected.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control system on using the cruise control main switch (ON/OFF button).
Push the cruise control main switch to -SET to begin control of vehicle speed using the cruise control system.
Depress the brake pedal for 0.4 seconds or more.
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
DTC P057504 and P057549 are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG