The millimeter wave radar sensor assembly communicates with each sensor and ECU via CAN communication.
If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0125 | Lost Communication with Yaw Rate Sensor Module | While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, a communication error between the yaw rate sensor and the millimeter wave radar sensor assembly is detected for approximately 1 second or more. | ·
CAN communication system ·
Yaw rate sensor (airbag sensor assembly) ·
Millimeter wave radar sensor assembly |
| U0126 | Lost Communication with Steering Angle Sensor Module | While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, a communication error between the steering sensor and the millimeter wave radar sensor assembly is detected for approximately 1 second or more. | ·
CAN communication system ·
Steering sensor ·
Millimeter wave radar sensor assembly |
| U0129 | Lost Communication with Brake System Control Module | While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, a communication error between the skid control ECU (brake booster with master cylinder assembly) and the millimeter wave radar sensor assembly is detected for approximately 2.5 seconds or more. | ·
CAN communication system ·
Skid control ECU (brake booster with master cylinder assembly) ·
Millimeter wave radar sensor assembly |
| U0293 | Lost Communication with Hybrid Vehicle Control System | While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, a communication error between the hybrid vehicle control ECU and the millimeter wave radar sensor assembly is detected for approximately 0.8 seconds or more. | ·
CAN communication system ·
Millimeter wave radar sensor assembly ·
Hybrid vehicle control ECU |
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Turn the power switch on (IG).
Turn the dynamic radar cruise control system on using the cruise control main switch (ON/OFF button).
Drive the vehicle at 5 km/h (3 mph) or more for 5 seconds or more.
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC U0125, U0126, U0129 and U0293 are not output | A |
| DTC U0125, U0126, U0129 or U0293 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING