The hybrid vehicle control ECU communicates with each sensor and ECU via CAN communication.
If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U010087 | Lost Communication With ECM/PCM "A" Missing Message | While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, the hybrid vehicle control ECU continuously receives a communication cut-off signal from the skid control ECU (brake booster with master cylinder assembly) for approximately 1 second or more. | ·
CAN communication system ·
Hybrid vehicle control ECU ·
Skid control ECU (brake booster with master cylinder assembly) |
| U012287 | Lost Communication with Vehicle Dynamics Control Module Missing Message | When the power switch on (IG) and the dynamic radar cruise control system is operating, a communication error between the skid control ECU (brake booster with master cylinder assembly) and the hybrid vehicle control ECU is detected for approximately 2.6 seconds or more. | ·
CAN communication system ·
Hybrid vehicle control ECU ·
Skid control ECU (brake booster with master cylinder assembly) |
| U110487 | Lost Communication with Cruise Control Module Missing Message | While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, a communication error between the millimeter wave radar sensor assembly and hybrid vehicle control ECU is detected for 1 second or more. | ·
CAN communication system ·
Hybrid vehicle control ECU ·
Millimeter wave radar sensor assembly |
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Turn the power switch on (IG).
Turn the dynamic radar cruise control system on using the cruise control main switch (ON/OFF button).
Drive the vehicle at 5 km/h (3 mph) or more for 5 seconds or more.
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC U010087, U012287 and U110487 are not output | A |
| DTC U010087, U012287 or U110487 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING