These DTCs are output when a communication malfunction occurs between the sensors and ECUs.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0123 | Lost Communication with Yaw Rate Sensor Module | 2 seconds after the power switch is turned on (IG), the vehicle is being driven at 1 km/h or 1 mph or more and a communication error between the yaw rate sensor and the forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Yaw rate and acceleration sensor (airbag sensor assembly) ·
Forward recognition camera |
| U0126 | Lost Communication With Steering Angle Sensor Module | 2 seconds after the power switch is turned on (IG), a communication error between the steering angle sensor and the forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Steering angle sensor (spiral cable sub-assembly) ·
Forward recognition camera |
| U0129 | Lost Communication with Brake System Control Module | 2 seconds after the power switch is turned on (IG), a communication error between the skid control ECU (brake booster with master cylinder assembly) and the forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Skid control ECU (Brake booster with master cylinder assembly) ·
Forward recognition camera |
| U0131 | Lost Communication with Power Steering Control Module | When the vehicle is being driven at a speed of 5 km/h (3 mph) or more 2 seconds after the power switch is turned on (IG), a communication error between the power steering ECU assembly and the forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Power steering ECU assembly ·
Forward recognition camera |
| U0142 | Lost Communication with Body Control Module "B" | 2 seconds after the power switch is turned on (IG), a communication error between the main body ECU (multiplex network body ECU) and the forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Main body ECU (Multiplex network body ECU) ·
Forward recognition camera |
| U0155 | Lost Communication with Combination Meter | 2 seconds after the power switch is turned on (IG), a communication error between the combination meter assembly and the forward recognition camera is detected for approximately 50 seconds or more. | ·
CAN communication system ·
Combination meter assembly ·
Forward recognition camera |
| U0235 | Lost Communication with Cruise Control Front Distance Range Sensor | When the vehicle is being driven at a speed of 5 km/h (3 mph) or more 2 seconds after the power switch is turned on (IG), a communication error between the millimeter wave radar sensor assembly and the forward recognition camera is detected for approximately 5 seconds. | ·
CAN communication system ·
Millimeter wave radar sensor assembly ·
Forward recognition camera |
| U0293 | Lost Communication with HV ECU | When the vehicle is being driven at a speed of 5 km/h (3 mph) or more 2 seconds after the power switch is turned on (IG), a communication error between the hybrid vehicle control ECU and the forward recognition camera is detected for approximately 5 seconds. | ·
CAN communication system ·
Hybrid vehicle control ECU ·
Forward recognition camera |
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / LKA/LDA / Trouble Codes.
Clear the DTCs.
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Turn the power switch on (IG) and wait 1 minute or more.
Drive the vehicle at a speed of 1 km/h or 1 mph or more for 5 seconds or more.
Enter the following menus: Chassis / LKA/LDA / Trouble Codes.
Check the DTCs.
| Result | Proceed to |
|---|---|
| DTC U0123, U0126, U0129, U0131, U0142, U0155, U0235 and U0293 are not output | A |
| DTC U0123, U0126, U0129, U0131, U0142, U0155, U0235 or U0293 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING