The combination meter assembly receives vehicle speed signals from the brake actuator assembly (skid control ECU) via CAN communication. The speed sensor detects the wheel speed and sends the appropriate signals to the brake actuator assembly (skid control ECU). The brake actuator assembly (skid control ECU) supplies power to the vehicle speed sensor. The brake actuator assembly (skid control ECU) detects vehicle speed signals based on pulses of the voltage.
Factors that affect the indicated vehicle speed include the tire size, tire inflation, and tire wear. The speed indicated on the speedometer has an allowable margin of error. This can be tested using the GTS. For details about testing and the margin of error, see the reference chart.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>ON-VEHICLE INSPECTION
If the vehicle speed sensor circuit has a malfunction, the brake actuator assembly (skid control ECU) stores DTCs. Troubleshoot the electronically controlled brake system.
If the vehicle speed is outside the allowable range when tested, perform the on-vehicle inspection.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>ON-VEHICLE INSPECTION
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Before starting the following inspection, check tire size and tire air pressure.
Check for DTCs.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTCs are not output. | A |
| DTCs are output. | B |
A
B
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output. | A |
| DTCs are output. | B |
A
B
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Speed Meter Operation | Speedometer | OFF, 0, 40, 80, 120, 160, 200, 240, 280 | There is a deviation in the values displayed on the speedometer (Control range → Speedometer display)
(1) for Gauge speedometer (Type A) Reference km/h: ·
40 → 38.0 to 42.0 ·
80 → 78.0 to 84.0 ·
120 → 119.0 to 125.0 ·
160 → 159.0 to 167.0 ·
200 → 199.0 to 209.0 (2) for Gauge speedometer (Type B) Reference km/h: ·
40 → 40.6 to 44.6 ·
80 → 81.2 to 85.2 ·
120 → 121.8 to 1125.8 ·
160 → 162.4 to 166.4 ·
200 → 203.0 to 207.0 (3) for Gauge speedometer (Type C) Reference mph: ·
40 → 40.0 to 43.5 ·
80 → 80.0 to 84.5 ·
120 → 120.0 to 125.5 |
| Tester Display |
|---|
| Speed Meter Operation |
Speedometer indication is normal.
| Result | Proceed to |
|---|---|
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
A
B
C