Home › General › SPECIFICATIONS › ALIGNMENT / HANDLING DIAGNOSIS › 2016.10–2019.09
RM32K0E _V1 General _059401 SPECIFICATIONS _0304937 ALIGNMENT / HANDLING DIAGNOSIS F

SPECIFICATIONS  ALIGNMENT / HANDLING DIAGNOSIS  SERVICE DATA  


Vehicle Height (Unloaded Vehicle):
Front A - B Rear C - D
121 mm (4.76 in.) 43 mm (1.69 in.)


Measurement Points:

A: Ground clearance of front wheel center


B: Ground clearance of front lower No. 1 suspension arm sub-assembly x front suspension crossmember sub-assembly set bolt center


C: Ground clearance of rear wheel center


D: Ground clearance of rear No. 2 suspension arm assembly x rear suspension member sub-assembly set bolt center


Camber (Unloaded Vehicle):
- Camber Inclination Right-left Difference
Front 0°02' +/- 0°45' (0.03° +/- 0.75°) 0°45' (0.75°) or less
Rear -0°51' +/- 0°45' (-0.85° +/- 0.75°) 0°45' (0.75°) or less


Caster (Unloaded Vehicle):
Tire Size Caster Inclination Right-left Difference
215/65R16
215/60R17
6°46' +/- 0°45' (6.77° +/- 0.75°) 0°45' (0.75°) or less
225/50R18 6°47' +/- 0°45' (6.78° +/- 0.75°) 0°45' (0.75°) or less


Steering Axis Inclination (Unloaded Vehicle):
Caster Inclination
14°01' (14.02°)


Toe-in (Unloaded Vehicle):
- Specified Condition
Front C + D: 0°07' +/- 0°10' (0.12° +/- 0.17°)
B - A: 1.5 +/- 2.0 mm (0.0591 +/- 0.0787 in.)
Rear C + D: 0°15' +/- 0°10' (0.25° +/- 0.17°)
B - A: 3.0 +/- 2.0 mm (0.118 +/- 0.0787 in.)


Wheel Turning Angle (Unloaded Vehicle):
Inside Wheel Outside Wheel
39°16' +/- 2°00' (39.27° +/- 2.00°) 33°35' (33.58°)