Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM › from 2018.05
RM32K0E _54 Brake _060048 PARKING BRAKE _0296497 ELECTRIC PARKING BRAKE SYSTEM C

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM  U0073  Control Module Communication Bus OFF  U0100  Lost Communication With ECM/PCM "A"  U0124  Lost Communication With Lateral Acceleration Sensor Module  U0129  Lost Communication with Brake System Control Module  U0293  Lost Communication With Hybrid Vehicle Control System  


DESCRIPTION

The parking brake ECU (brake actuator assembly) communicates with the hybrid vehicle control ECU, skid control ECU (brake booster with master cylinder assembly) and deceleration sensor (airbag sensor assembly) via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note
U0073 Control Module Communication Bus OFF Both of following conditions are met:
1.

Power switch on (IG).

2.

Bus is off (communication with other ECUs is not possible).


CAN communication system DTC stored An electric parking brake system malfunction is displayed on the multi-information display.
U0100 Lost Communication With ECM/PCM "A" Both of following conditions are met:
1.

Vehicle being driven at 15 km/h (9 mph) or more.

2.

Parking brake ECU (brake actuator assembly) cannot receive signals from the ECM for approximately 1 second or 10 seconds (malfunction detection duration differs depending on the signal).


·

CAN communication system

·

ECM


DTC stored An electric parking brake system malfunction is displayed on the multi-information display.
U0124 Lost Communication With Lateral Acceleration Sensor Module Both of following conditions are met:
1.

Vehicle is being driven at 7 km/h (4.3 mph) or more.

2.

Parking brake ECU (brake actuator assembly) cannot receive signals from the deceleration sensor (airbag sensor assembly).


·

CAN communication system

·

Deceleration sensor (Airbag sensor assembly)


DTC stored An electric parking brake system malfunction is displayed on the multi-information display.
U0129 Lost Communication with Brake System Control Module Both of following conditions are met:
1.

Power switch on (IG).

2.

Parking brake ECU (brake actuator assembly) cannot receive signals from the skid control ECU (brake booster with master cylinder assembly) for approximately 1 second or 10 seconds (malfunction duration differs depending on the signal).


·

CAN communication system

·

Skid control ECU (brake booster with master cylinder assembly)


DTC stored An electric parking brake system malfunction is displayed on the multi-information display.
U0293 Lost Communication With Hybrid Vehicle Control System Both of following conditions are met:
1.

Vehicle being driven at 15 km/h (9 mph) or more.

2.

Parking brake ECU (brake actuator assembly) cannot receive signals from the hybrid vehicle control ECU assembly for approximately 1 second or 10 seconds (malfunction detection duration differs depending on the signal).


·

CAN communication system

·

Hybrid vehicle control ECU


DTC stored An electric parking brake system malfunction is displayed on the multi-information display.

PROCEDURE

1.GO TO CAN COMMUNICATION SYSTEM

Result:
Proceed to
NEXT



NEXT

END