Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2018.05–2019.09
RM32K0E _58 Vehicle Interior _062180 METER / GAUGE / DISPLAY _0304590 METER / GAUGE SYSTEM G

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 83100 1.INSPECT COMBINATION METER ASSEMBLY

a.

Check speedometer operation

NOTICE:
·

The combination meter assembly receives the vehicle speed signal from the brake actuator assembly (skid control ECU) via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the brake actuator assembly (skid control ECU) because it is the source of the vehicle speed signal.

·

Data List values of the brake actuator assembly (skid control ECU) are used for this inspection. Therefore, make sure to perform this inspection after confirming that DTCs are not output.

·

If the tire size or tire inflation pressure is not within the specified range, or the tires are excessively worn, the speedometer indication error will increase. Therefore, make sure to perform this inspection after checking that the tire size, tire inflation pressure and tire wear are in the specified range.



i.

Warm up the engine.


ii.

Connect the GTS to the DLC3.


iii.

Turn the power switch on (IG).


iv.

Turn the GTS on.


v.

Enter the following menus: Chassis / ABS/VSC/TRC / Data List.


vi.

Read the Data List according to the display on the GTS.

Chassis > ABS/VSC/TRC > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Vehicle Speed Maximum wheel speed sensor reading Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
Chassis > ABS/VSC/TRC > Data List
Tester Display
Vehicle Speed
50003 105 42
Reference km/h (Type A)
GTS Indication (km/h) Acceptable Range (km/h)
20 17.5 to 21.5
40 38.0 to 42.0
60 58.0 to 63.0
80 78.0 to 84.0
100 98.5 to 104.5
120 119.0 to 125.0
140 139.0 to 146.0
160 159.0 to 167.0
180 179.0 to 188.0
200 199.0 to 209.0
220 219.0 to 230.0

Reference km/h (Type B)
GTS Indication (km/h) Acceptable Range (km/h)
20 20.3 to 24.3
40 40.6 to 44.6
60 60.9 to 64.9
80 81.2 to 85.2
100 101.5 to 105.5
120 121.8 to 125.8
140 142.1 to 146.1
160 162.4 to 166.4
180 182.7 to 186.7
200 203.0 to 207.0
220 223.3 to 227.3

Reference mph (Type C)
GTS Indication (mph) Acceptable Range (mph)
20 20.0 to 23.0
40 40.0 to 43.5
60 60.0 to 64.0
80 80.0 to 84.5
100 100.0 to 105.0
120 120.0 to 125.5
140 140.0 to 146.0

OK:

Speedometer reading is within the acceptable range at each vehicle speed.




b.

Check LED illumination (LED check)

i.

Check the illumination function of the warning or indicator lights listed below when turning the power switch on (IG).

OK:
Warning or Indicator Light Control ECU Specified Condition
Brake warning light Brake actuator assembly (Skid control ECU) Warning or indicator light comes on for about 3 seconds after turning the powerswitch to on (IG).
VSC OFF indicator light Brake actuator assembly (Skid control ECU)
Slip indicator light Brake actuator assembly (Skid control ECU)
ABS warning light Brake actuator assembly (Skid control ECU)
Tire pressure warning light Tire pressure warning and ECU receiver
PCS warning light*1 Millimeter wave radar sensor assembly
Automatic high beam indicator light*1 Main body ECU (Multiplex network body ECU)
EPB indicator light Brake actuator assembly (Skid control ECU)
EPB warning light Brake actuator assembly (Skid control ECU)
High beam indicator light Main body ECU (Multiplex network body ECU)
BSM indicator light*2 Blind spot monitor sensor LH
RCTA indicator light*2 Blind spot monitor sensor LH
SRS warning light Airbag sensor assembly Warning light comes on for about 6 seconds after turning the power switch to on (IG).
Charge warning light ECM Warning light comes on when the power switch to on (IG).
MIL (Check engine warning light) ECM
EPS warning light Power steering ECU assembly
IPA indicator light*2 Clearance warning ECU assembly


*1: w/ Toyota Safety Sense

*2: w/ Blind Spot Monitor System