Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2018.05–2020.08
RM32K0E _51 Engine / Hybrid System _061336 CRUISE CONTROL _0304571 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  U010087  Lost Communication With ECM/PCM "A" Missing Message  U010487  Lost Communication with Cruise Control Module Missing Message  U012287  Lost Communication with Vehicle Dynamics Control Module Missing Message  


DESCRIPTION

The hybrid vehicle control ECU communicates with each sensor and ECU via CAN communication.

If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
U010087 Lost Communication With ECM/PCM "A" Missing Message While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, the hybrid vehicle control ECU continuously receives a communication cut-off signal from the skid control ECU (brake booster with master cylinder assembly) for approximately 1 second or more.
·

CAN communication system

·

Hybrid vehicle control ECU

·

Skid control ECU (brake booster with master cylinder assembly)


U010487 Lost Communication with Cruise Control Module Missing Message While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, a communication error between the millimeter wave radar sensor assembly and hybrid vehicle control ECU is detected for 1 second or more.
·

CAN communication system

·

Hybrid vehicle control ECU

·

Millimeter wave radar sensor assembly


U012287 Lost Communication with Vehicle Dynamics Control Module Missing Message When the power switch on (IG) and the dynamic radar cruise control system is operating, a communication error between the skid control ECU (brake booster with master cylinder assembly) and the hybrid vehicle control ECU is detected for approximately 2.6 seconds or more.
·

CAN communication system

·

Hybrid vehicle control ECU

·

Skid control ECU (brake booster with master cylinder assembly)



PROCEDURE

1.CHECK FOR DTCs (CRUISE CONTROL)
a.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Cruise Control > Clear DTCs
50002 399

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.

1.

Turn the power switch on (IG).

2.

Turn the dynamic radar cruise control system on using the cruise control main switch (ON/OFF button).

3.

Drive the vehicle at 5 km/h (3 mph) or more for 5 seconds or more.




c.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Cruise Control > Trouble Codes
50001 399

Result:
Result Proceed to
DTC U010087, U010487 and U012287 are not output A
DTC U010087, U010487 or U012287 is output B



A

B