67881A
1.INSTALL BACK DOOR WEATHERSTRIP
for TMMT Made:
Remove any non-drying sealer on the body with non-residue solvent.
| *a | Paint Mark |
| *b | Mark Position |
Align the paint marks with the positions on the body flange and install a new back door weatherstrip.
| Location | Color |
|---|---|
| Center | Green |
| Side | Blue |
Always align the paint mark when installing the part. If the paint mark position is out of place, coolant leaks may occur.
After the installation, check that the corners are properly installed.
To easily install the weatherstrip, first install the area with the paint mark as shown in the illustration. Then install the part toward the corners and push any excess length into the corners.
for TMC Made:
Remove any non-drying sealer on the body with non-residue solvent.
| *a | Paint Mark |
| *b | Mark Position |
Align the paint marks with the positions on the body flange and install a new back door weatherstrip.
| Location | Color |
|---|---|
| Center | Yellow Green |
| Corner | Light Blue |
Always align the paint mark when installing the part. If the paint mark position is out of place, coolant leaks may occur.
After the installation, check that the corners are properly installed.
To easily install the weatherstrip, first install the area with the paint mark as shown in the illustration. Then install the part toward the corners and push any excess length into the corners.