Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › from 2019.09
RM32K0E _58 Vehicle Interior _062180 METER / GAUGE / DISPLAY _0304590 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Engine Coolant Temperature Receiver Gauge Malfunction  


DESCRIPTION

In this circuit, the combination meter assembly receives engine coolant temperature signals from the ECM via CAN communication. The combination meter assembly displays the engine coolant temperature that is calculated based on the data received from the ECM.

WIRING DIAGRAM

E341411E02
0.573,3.094 1.125,3.323 0.552,0.229 10 false ECM 2.948,3.188 4.844,3.385 1.896,0.198 10 false : CAN Communication Line 5.281,3.104 7.135,3.427 1.854,0.323 10 false Combination Meter Assembly

CAUTION / NOTICE / HINT

NOTICE:
·

Before replacing the ECM, refer to Service Bulletin.

·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.



HINT:

If there is an open or short in the engine coolant temperature sensor circuit, the ECM stores DTCs. Troubleshoot the SFI system.



PROCEDURE

1.CHECK FOR DTC (METER / GAUGE SYSTEM)

Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B



A

2.CHECK FOR DTC (SFI SYSTEM)

B

2.CHECK FOR DTC (SFI SYSTEM)

Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B



A

3.PERFORM ACTIVE TEST USING GTS (ENGINE COOLANT TEMPERATURE)

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

3.PERFORM ACTIVE TEST USING GTS (ENGINE COOLANT TEMPERATURE)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus:

i.

for Engine: Powertrain / Engine / Data List.


ii.

for Combination Meter: Body Electrical / Combination Meter / Data List.



e.

Read the Data List according to the display on the GTS.

i.

Engine.

Powertrain > Engine > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Coolant Temperature Engine coolant temperature Min.: -40°C (-40°F), Max.: 140°C (284°F) 75 to 100°C (167 to 212°F): After warming up engine This is the engine coolant temperature.
·

After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F).

·

After a long soak, the engine coolant temperature, intake air temperature and ambient temperature are approximately equal.

·

If the value is -40°C (-40°F), or 135°C (275°F), the sensor circuit is open or shorted.

·

Check if the engine overheats when the value indicates 135°C (275°F).


Powertrain > Engine > Data List
Tester Display
Coolant Temperature
50003 372 205

ii.

Combination Meter.

Body Electrical > Combination Meter > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Coolant Temperature Engine coolant temperature Min.: 0°C (0°F), Max.: 127.5°C (261.5°F) 75 to 100°C (167 to 212°F): After warming up engine -
Body Electrical > Combination Meter > Data List
Tester Display
Coolant Temperature
50003 122 10
Result:
Result Proceed to
The Data List values of the ECUs do not match (for 2ZR-FXE) A
The Data List values of the ECUs do not match (for M20A-FXS) B
The Data List values of the ECUs match C


HINT:
·

When the Data List values of the ECUs match, an internal malfunction of the ECM is suspected.

·

When the Data List values of the ECUs do not match, a signal output malfunction of the ECM or an internal malfunction of the combination meter assembly is suspected.






A

B

C

REPLACE COMBINATION METER ASSEMBLY