Home › Engine / Hybrid System › M20A-FXS (INTAKE / EXHAUST) › INTAKE SYSTEM › from 2019.09
RM32K0E _51 Engine / Hybrid System _083957 M20A-FXS INTAKE / EXHAUST _0404360 INTAKE SYSTEM G

M20A-FXS INTAKE / EXHAUST  INTAKE SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced when repairing air leaks in the intake system are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Air leak from intake system is repaired Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 1.INSPECT INTAKE SYSTEM

CAUTION:
A379926

To prevent injury due to contact with an operating cooling fan, keep your hands and clothing away from the cooling fans when working in the engine compartment with the engine running or the power switch on (IG).


HINT:

Perform "Inspection After Repair" after repairing vacuum leaks in the intake system.

Click hereEngine / Hybrid System>M20A-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.

Check that there are no vacuum leaks at the points shown in the illustration.

A439811


Hide 2.PERFORM INITIALIZATION

a.

Perform Inspection After Repair after repairing vacuum leaks in the intake system.

Click hereEngine / Hybrid System>M20A-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION