Home › Engine / Hybrid System › 2ZR-FXE (HYBRID / BATTERY CONTROL) › ACCELERATOR PEDAL SENSOR › from 2019.09
RM32K0E _51 Engine / Hybrid System _083958 2ZR-FXE HYBRID / BATTERY CONTROL _0404383 ACCELERATOR PEDAL SENSOR A

2ZR-FXE HYBRID / BATTERY CONTROL  ACCELERATOR PEDAL SENSOR  INSTALLATION  


PROCEDURE

Hide 78110K 1.INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY (for LHD)

NOTICE:
·

Avoid physical shock to the accelerator pedal sensor assembly.

·

Do not disassemble the accelerator pedal sensor assembly.

·

The accelerator pedal sensor assembly does not require lubrication.

·

Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.



a.

Install the accelerator pedal sensor assembly with the 3 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:

If the accelerator pedal sensor assembly has been struck or dropped, replace it.



b.

Connect the accelerator pedal sensor assembly connector.


Hide 78110K 2.INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY (for RHD)

NOTICE:
·

Avoid physical shock to the accelerator pedal sensor assembly.

·

Do not disassemble the accelerator pedal sensor assembly.

·

The accelerator pedal sensor assembly does not require lubrication.

·

Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.



a.

Install the accelerator pedal sensor assembly with the 3 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:

If the accelerator pedal sensor assembly has been struck or dropped, replace it.



b.

Connect the accelerator pedal sensor assembly connector.