Home › Vehicle Interior › SEAT › LUMBAR SWITCH › 2019.09–2020.08
RM32K0E _58 Vehicle Interior _061825 SEAT _0301290 LUMBAR SWITCH A

SEAT  LUMBAR SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front lumbar power seat switch removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

CAUTION:
·
B458500

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·
B407261

Wear protective gloves. Sharp areas on the parts may injure your hands.



HINT:
·

Front lumbar power seat switch is available only on the driver side.

·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 71074S 2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

Hide 72495 3.REMOVE VERTICAL ADJUSTING HANDLE

Hide 72538 4.REMOVE RECLINING HINGE OUTER COVER

Hide 72526A 5.REMOVE RECLINING ADJUSTER RELEASE HANDLE

Hide 71849F 6.REMOVE SEAT ADJUSTER COVER CAP

Hide 71812D 7.REMOVE FRONT SEAT CUSHION SHIELD

Hide 84922A 8.REMOVE FRONT LUMBAR POWER SEAT SWITCH

a.
B453969

Remove the 2 screws.


b.

Disengage the guides to remove the front lumbar power seat switch.