Home › Engine / Hybrid System › M20A-FXS (HYBRID / BATTERY CONTROL) › ACCELERATOR PEDAL SENSOR › from 2019.09
RM32K0E _51 Engine / Hybrid System _083959 M20A-FXS HYBRID / BATTERY CONTROL _0404422 ACCELERATOR PEDAL SENSOR A

M20A-FXS HYBRID / BATTERY CONTROL  ACCELERATOR PEDAL SENSOR  REMOVAL  


PROCEDURE

Hide 78110K 1.REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY

NOTICE:
·

Avoid physical shock to the accelerator pedal sensor assembly.

·

Do not disassemble the accelerator pedal sensor assembly.

·

The accelerator pedal sensor assembly does not require lubrication.

·

Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.



a.
A438999C01
0.031,0.031 0.365,0.281 0.333,0.25 12 true *A 0.021,2.375 0.365,2.625 0.344,0.25 12 true *B
*A for LHD
*B for RHD


Disconnect the accelerator pedal sensor assembly connector.


b.

Remove the 3 nuts and accelerator pedal sensor assembly.

NOTICE:

If the accelerator pedal sensor assembly has been struck or dropped, replace it.