Home › Engine / Hybrid System › M20A-FXS (HYBRID / BATTERY CONTROL) › ACCELERATOR PEDAL SENSOR › from 2019.09
RM32K0E _51 Engine / Hybrid System _083959 M20A-FXS HYBRID / BATTERY CONTROL _0404422 ACCELERATOR PEDAL SENSOR G

M20A-FXS HYBRID / BATTERY CONTROL  ACCELERATOR PEDAL SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78110K 1.INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Hybrid Control / Data List / Accel Position Sensor No. 1 Voltage and Accel Position Sensor No. 2 Voltage.

Powertrain > Hybrid Control > Data List
Tester Display
Accelerator Position Sensor No.1 Voltage %
Accelerator Position Sensor No.2 Voltage %
50003 397 23,24

e.

Read the values displayed on the GTS.

Standard Voltage:
Tester Display Accelerator Pedal Condition Specified Condition
Accelerator Position Sensor No. 1 Voltage % Not depressed 10 to 22%
Fully depressed 52 to 90%
Not depressed → Fully depressed → Not depressed (Accelerator pedal should be operated slowly) Value changes progressively
Accelerator Position Sensor No. 2 Voltage % Not depressed 24 to 40%
Fully depressed 68 to 99%
Not depressed → Fully depressed → Not depressed (Accelerator pedal should be operated slowly) Value changes progressively


If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.