Home › Engine / Hybrid System › M20A-FXS (FUEL) › FUEL MAIN VALVE › 2019.09–2020.08
RM32K0E _51 Engine / Hybrid System _083996 M20A-FXS FUEL _0404503 FUEL MAIN VALVE A

M20A-FXS FUEL  FUEL MAIN VALVE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the fuel main valve assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Parking Support Brake System*1
Toyota parking assist-sensor system*1
Pre-collision System
Initialize back door lock Power door lock control system (Click here)

CAUTION:
·
A360563

Never perform work on fuel system components near any possible ignition sources.

·

Vaporized fuel could ignite, resulting in a serious accident.

·
A360564

Do not perform work on fuel system components without first disconnecting the cable from the negative (-) auxiliary battery terminal.

·

Sparks could cause vaporized fuel to ignite, resulting in a serious accident.



PROCEDURE

Hide 77020A 1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Hide 2.REMOVE NO. 2 FUEL SUCTION SUPPORT

a.
A435048

Disengage the 3 claws and remove the No. 2 fuel suction support from the fuel suction tube with pump and gauge assembly.


Hide 23070 3.REMOVE FUEL MAIN VALVE ASSEMBLY

a.
A435049C02
2.948,0.896 2.729,0.896 2.729,0.896 2.375,0.521 true 2.979,0.792 3.313,1.208 0.333,0.417 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped with protective tape, remove the fuel main valve assembly from the fuel suction tube with pump and gauge assembly.

NOTICE:

Pull out the fuel main valve assembly carefully because the O-ring is firmly installed between the fuel main valve assembly and the fuel suction tube with pump and gauge assembly.



b.
A434943C03
1.573,0.698 1.854,0.302 false 1.865,0.208 2.177,0.365 0.313,0.156 10 false *1
*1 O-ring


Remove the O-ring from the fuel main valve assembly.