Home › General › MAINTENANCE › M20A-FXS AUXILIARY BATTERY › 2019.09–2020.08
RM32K0E _V1 General _059911 MAINTENANCE _0404803 M20A-FXS AUXILIARY BATTERY A

MAINTENANCE  M20A-FXS AUXILIARY BATTERY  INSTALLATION  


PROCEDURE

Hide 1.INSTALL AUXILIARY BATTERY

a.

Install the auxiliary battery to the vehicle.


b.

Install the battery clamp sub-assembly with the bolt and nut.

Torque:
Bolt : 16.5 N*m (168 kgf*cm, 12 ft.*lbf)
Nut : 7.2 N*m (73 kgf*cm, 64 in.*lbf)


c.

Connect the auxiliary battery hose.


d.

Connect the cable to the positive (+) auxiliary battery terminal.


e.

Tighten the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


f.
A429315C01
0,0 0,0 false
V113147

Close


Engage the claw to close the battery terminal cap shown in the illustration.


Hide 2.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

a.

Connect the cable to the negative (-) auxiliary battery terminal and tighten the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



Hide 58440 3.INSTALL BATTERY SERVICE HOLE COVER ASSEMBLY (w/o Spare Tire)

a.

install the battery service hole cover assembly.


Hide 58410B 4.INSTALL DECK BOARD ASSEMBLY