Home › General › SPECIFICATIONS › P711 HYBRID TRANSMISSION / TRANSAXLE › from 2019.09
RM32K0E _V1 General _059401 SPECIFICATIONS _0404805 P711 HYBRID TRANSMISSION / TRANSAXLE F

SPECIFICATIONS  P711 HYBRID TRANSMISSION / TRANSAXLE  SERVICE DATA  


Hybrid Transaxle System
Maintenance mode engine idle speed Hybrid transaxle fluid temperature Hybrid transaxle fluid pressure
1050 to 1150 rpm 20 to 50°C (68 to 122°F) 9.8 kPa (0.1 kgf/cm2, 1 psi) or more

Hybrid Transaxle Fluid
Hybrid transaxle fluid standard capacity (for Reference) Classification
3.8 liters (4.0 US qts, 3.3 Imp. qts) Toyota Genuine ATF WS

Hybrid Transaxle Oil Seal
Front drive shaft oil seal RH Standard depth -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
Front drive shaft oil seal LH Standard depth -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

Input Shaft Oil Seal
Input shaft type T oil seal Standard depth 1.9 to 2.7 mm (0.0748 to 0.106 in.)

Shift Lever
Shift Lock control ECU
Wire harness
Tester Connection Condition Specified Condition
4 (STP) - Body ground Ready ON, brake pedal released 11 to 14 V
Ready ON, brake pedal released Below 1 Ω
5 (IG) - Body ground Power switch on (IG) 11 to 14 V
Power switch off Below 1 V
1 (E) - Body ground Always Below 1 Ω
Shift lock solenoid
1 (SLS+) - 2 (SLS-) Always 112 Ω
4 (P) - 3 (E2) Shift lever in P 10 kΩ or higher
Shift lever not in P Below 1 Ω
TRANSMISSION CONTROL SWITCH (for LHD)
Tester Connection Condition Specified Condition
4 (IG) - 5 (M) Shift lever in M, "+" or "-" Below 1 Ω
Shift lever not in M, "+" or "-" 10 kΩ or higher
1 (SFTD) - 2 (E) Shift lever held in "-" (Down-shift) Below 1 Ω
Shift lever not in "-" 10 kΩ or higher
3 (SFTU) - 2 (E) Shift lever held in "+" (Up-shift) Below 1 Ω
Shift lever not in "+" 10 kΩ or higher
TRANSMISSION CONTROL SWITCH (for RHD)
Tester Connection Condition Specified Condition
4 (IG) - 5 (M) Shift lever in M, "+" or "-" Below 1 Ω
Shift lever not in M, "+" or "-" 10 kΩ or higher
1 (SFTU) - 2 (E) Shift lever held in "+" (Up-shift) Below 1 Ω
Shift lever not in "+" 10 kΩ or higher
3 (SFTD) - 2 (E) Shift lever held in "-" (Down-shift) Below 1 Ω
Shift lever not in "-" 10 kΩ or higher

Shift Lever Position Sensor
Tester Connection Condition Specified Condition
7 (+B) - 3 (PR) Shift lever in P Below 1 Ω
7 (+B) - 4 (PNB) Below 1 Ω
7 (+B) - 8 (P) Below 1 Ω
7 (+B) - 1 (DB1), 2 (N), 6 (DB2) or 9 (R) Shift lever in P 10 kΩ or higher
7 (+B) - 3 (PR) Shift lever in R Below 1 Ω
7 (+B) - 9 (R) Below 1 Ω
7 (+B) - 1 (DB1), 2 (N), 4 (PNB), 6 (DB2) or 8 (P) Shift lever in R 10 kΩ or higher
7 (+B) - 2 (N) Shift lever in N Below 1 Ω
7 (+B) - 4 (PNB) Below 1 Ω
7 (+B) - 1 (DB1), 3 (PR), 6 (DB2), 8 (P) or 9 (R) Shift lever in N 10 kΩ or higher
7 (+B) - 1 (DB1) Shift lever in D or B Below 1 Ω
7 (+B) - 6 (DB2) Below 1 Ω
7 (+B) - 2 (N), 3 (PR), 4 (PNB), 8 (P) or 9 (R) Shift lever in D or B 10 kΩ or higher