Home › Engine / Hybrid System › M20A-FXS (ENGINE CONTROL) › MASS AIR FLOW METER › from 2019.09
RM32K0E _51 Engine / Hybrid System _083960 M20A-FXS ENGINE CONTROL _0404837 MASS AIR FLOW METER A

M20A-FXS ENGINE CONTROL  MASS AIR FLOW METER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during mass air flow meter sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of mass air flow meter sub-assembly Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 22204 1.REMOVE MASS AIR FLOW METER SUB-ASSEMBLY

a.
A439257

Disconnect the mass air flow meter sub-assembly connector.


b.

Remove the 2 screws and mass air flow meter sub-assembly from the air cleaner cap sub-assembly.

NOTICE:

If the mass air flow meter sub-assembly has been struck or dropped, replace it.