Home › Engine / Hybrid System › M20A-FXS (ENGINE CONTROL) › CAMSHAFT POSITION SENSOR › from 2019.09
RM32K0E _51 Engine / Hybrid System _083960 M20A-FXS ENGINE CONTROL _0404838 CAMSHAFT POSITION SENSOR A

M20A-FXS ENGINE CONTROL  CAMSHAFT POSITION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 11102A 1.REMOVE CAMSHAFT POSITION SENSOR (for Intake Side)

a.
A433351

Disconnect the camshaft position sensor connector.


b.

Using an 8 mm socket wrench, remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.

NOTICE:

If the camshaft position sensor has been struck or dropped, replace it.



Hide 11102A 2.REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side)

a.
A439259

Disconnect the camshaft position sensor connector.


b.

Using an 8 mm socket wrench, remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.

NOTICE:

If the camshaft position sensor has been struck or dropped, replace it.