The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during spark plug removal/installation are shown below.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
19500
1.REMOVE IGNITION COIL ASSEMBLY
19100P
2.REMOVE SPARK PLUG
Remove the 4 spark plugs from the cylinder head sub-assembly.
If a spark plug has been struck or dropped, replace it.
Arrange the removed parts in the correct order.