Home › General › MAINTENANCE › M20A-FXS SPARK PLUG › from 2019.09
RM32K0E _V1 General _059911 MAINTENANCE _0404848 M20A-FXS SPARK PLUG A

MAINTENANCE  M20A-FXS SPARK PLUG  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 19100P 1.INSTALL SPARK PLUG

HINT:

Perform "Inspection After Repair" after replacing a spark plug.

Click hereEngine / Hybrid System>M20A-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.

Install the 4 spark plugs to the cylinder head sub-assembly.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:

If a spark plug has been struck or dropped, replace it.


HINT:

Install the same parts to their original positions.



Hide 3.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.

Click hereEngine / Hybrid System>M20A-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION