Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY (for 2ZR-FXE) › from 2019.09
RM32K0E _52 Drivetrain _061224 DRIVE SHAFT / PROPELLER SHAFT _0405859 FRONT DRIVE SHAFT ASSEMBLY(for 2ZR-FXE) G

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY(for 2ZR-FXE)  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT DRIVE SHAFT ASSEMBLY

a.
C287111

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no excessive play in the radial direction of the inboard joint.


d.

Check the boots for damage.


e.
C296188N06
1.438,1.656 1.865,1.99 0.427,0.333 10 false (A)

Check whether each drive shaft dimension (A) is within specification.

Dimension (A) (for TMMT made):
LH Side RH Side
590.5 mm (1.94 ft.) 887.2 mm (2.91 ft.)


Dimension (A) (for TMC made):
LH Side RH Side
591.2 mm (1.94 ft.) 895.2 mm (2.94 ft.)


NOTICE:

Keep the drive shaft assembly level during inspection.