Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY (for M20A-FXS) › from 2019.09
RM32K0E _52 Drivetrain _061224 DRIVE SHAFT / PROPELLER SHAFT _0405862 FRONT DRIVE SHAFT ASSEMBLY(for M20A-FXS) G

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY(for M20A-FXS)  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT DRIVE SHAFT ASSEMBLY

a.
C287111

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no excessive play in the radial direction of the inboard joint.


d.

Check the boots for damage.


e.
C296188N06
1.438,1.656 1.865,1.99 0.427,0.333 10 false (A)

Check whether each drive shaft dimension (A) is within specification.

Dimension (A):
LH Side RH Side
594.2 mm (1.95 ft.) 898.4 mm (2.95 ft.)


NOTICE:

Keep the drive shaft assembly level during inspection.