Home › Engine / Hybrid System › M20A-FXS (FUEL) › FUEL PUMP › from 2019.09
RM32K0E _51 Engine / Hybrid System _083996 M20A-FXS FUEL _0404504 FUEL PUMP A

M20A-FXS FUEL  FUEL PUMP  DISASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:
A440659C01
0.948,1.219 1.375,1.219 true 0.76,1.125 0.99,1.375 0.229,0.25 10 false *a
*a Tube


Do not disconnect the tube shown in the illustration when disassembling the fuel suction tube with pump and gauge assembly. Doing so will cause reassembly of the fuel suction tube with pump and gauge assembly to be impossible as the tube is pressed into the fuel suction plate sub-assembly.


PROCEDURE

Hide 83320 1.REMOVE FUEL SENDER GAUGE ASSEMBLY

Hide 23221 2.REMOVE FUEL PUMP

a.
A440660

Disconnect the 2 fuel pump harness connectors.


b.

Disengage the clamp to remove the fuel pump harness from the fuel suction tube with pump and gauge assembly.

NOTICE:
·

Do not damage the wire harness.

·

When disengaging each wire harness from the clamp, disengage one wire at a time.




c.
A435366C03
2.583,0.792 2.99,0.792 true 3.031,0.708 3.271,0.896 0.24,0.188 10 false *1
*1 Fuel Suction Plate Sub-assembly
V100135

Pull
V100136

Slide


Disengage the claw and slide the fuel suction plate sub-assembly and then separate it from the fuel sub-tank sub-assembly.


d.
A440661

Disengage the 4 claws, and remove the fuel pump from the fuel sub-tank sub-assembly.

NOTICE:

Do not do anything which may separate the tube from either the fuel suction plate sub-assembly or fuel filter, such as applying excessive force to the tube.

Click hereEngine / Hybrid System>M20A-FXS (FUEL)>FUEL SYSTEM>PRECAUTION



e.
A432740C02
0.906,2.677 0.906,3.01 false 0.833,3.031 1.094,3.281 0.26,0.25 10 false *a
*a No. 1 Fuel Suction Support


Disengage the 3 claws, and remove the fuel pump from the No. 1 fuel suction support.


f.

Remove the O-ring from the fuel pump.

NOTICE:

Be careful not to damage the sealing surface.