The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front axle hub sub-assembly on-vehicle inspection are shown below.
When removing or installing the front disc brake caliper assembly, pushing back the disc brake piston may cause a large clearance between the brake pads and brake disc. When the brake pedal is depressed with a large clearance between the brake pads and the brake disc, DTC C1214 related to abnormal brake fluid pressure may be stored. Make sure to clear any DTCs after performing this step.
While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISABLE BRAKE CONTROL
for TMC Made:
Click hereBrake>BRAKE (FRONT)>FRONT BRAKE (for TMC Made)>REMOVAL
for TMMT Made:
Click hereBrake>BRAKE (FRONT)>FRONT BRAKE (for TMMT Made)>REMOVAL
3.REMOVE FRONT WHEEL
4.SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY
43512
5.REMOVE FRONT DISC
for TMC Made:
Click hereBrake>BRAKE (FRONT)>FRONT BRAKE (for TMC Made)>REMOVAL
for TMMT Made:
Click hereBrake>BRAKE (FRONT)>FRONT BRAKE (for TMMT Made)>REMOVAL
6.INSPECT FRONT AXLE HUB BEARING LOOSENESS
Using a dial indicator, check for looseness near the center of the front axle hub sub-assembly.
0.05 mm (0.00196 in.)
Ensure that the dial indicator is set perpendicular to the measurement surface.
Keep the magnet of the dial indicator away from the front axle hub sub-assembly and front speed sensor.
If the looseness exceeds the maximum, replace the front axle hub sub-assembly.
7.INSPECT FRONT AXLE HUB RUNOUT
Using a dial indicator, check for runout on the surface of the front axle hub sub-assembly outside the front axle hub bolts.
0.05 mm (0.00196 in.)
Ensure that the dial indicator is set perpendicular to the measurement surface.
Make sure to set the tip of the dial indicator towards the outside of the front axle hub bolts.
Keep the magnet of the dial indicator away from the front axle hub sub-assembly and front speed sensor.
If the runout exceeds the maximum, replace the front axle hub sub-assembly.
43512
8.INSTALL FRONT DISC
for TMC Made:
Click hereBrake>BRAKE (FRONT)>FRONT BRAKE (for TMC Made)>INSTALLATION
for TMMT Made:
Click hereBrake>BRAKE (FRONT)>FRONT BRAKE (for TMMT Made)>INSTALLATION
9.INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
10.INSTALL FRONT WHEEL
11.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Connect the reservoir level switch connector.
Connect the cable to the negative (-) auxiliary battery terminal.
Click hereGeneral>MAINTENANCE>2ZR-FXE AUXILIARY BATTERY>INSTALLATION
Turn the power switch on (READY).
Depress the brake pedal and release it.
Clear the DTCs.