Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY (for Triple Beam Headlight) › from 2019.09
RM32K0E _59 Vehicle Exterior _061162 LIGHTING (EXT) _0406612 HEADLIGHT ASSEMBLY(for Triple Beam Headlight) A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY(for Triple Beam Headlight)  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.INSTALL FRONT SIDE MARKER LIGHT BULB (w/ Side Marker Light)

a.
E368089C01
0,0 0,0 false
V113147

Install in this Direction


Install the front side marker light bulb to the front side marker light socket as shown in the illustration.


b.
E426105C01
0,0 0,0 false
V113147

Install in this Direction


Turn the front side marker light socket with the front side marker light bulb as shown in the illustration to install them as a unit.


Hide 81510C 2.INSTALL FRONT TURN SIGNAL LIGHT BULB

a.
E426126C01
0,0 0,0 false
V113147

Install in this Direction


Turn the front turn signal light bulb to install it to the front turn signal light socket as shown in the illustration.


b.
E420069C01
0,0 0,0 false
V113147

Install in this Direction


Turn the front turn signal light socket with the front turn signal light bulb as shown in the illustration to install them as a unit.


Hide 81194A 3.INSTALL HEADLIGHT PROTECTOR

a.

Clean the headlight assembly surface.

i.

Remove the double-sided tape from the headlight assembly surface.


ii.

Wipe off any tape adhesive residue with cleaner.



b.

Remove the peeling paper from a new headlight protector.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



c.
E420064

Install the headlight protector.

NOTICE:

Make sure to apply sufficient pressure to the portions with double-sided tape of the headlight protector to ensure the tape is securely adhered.