Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.INSTALL HEADLIGHT ASSEMBLY
|
Install in this Direction |
Temporarily install the headlight assembly as shown in the illustration.
Install the headlight assembly with the bolt and 3 screws.
|
Protective Tape |
Connect the 2 connectors B.
w/ Side Marker Light:
Connect the connector A.
Remove the protective tape.
85319A
2.INSTALL INLET HOSE (for RH Side)
Install the inlet hose with the clip.
3.INSTALL FRONT BUMPER ASSEMBLY
4.PERFORM INITIALIZATION
5.ADJUST HEADLIGHT AIMING