Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY (for Single Beam Headlight) › from 2019.09
RM32K0E _59 Vehicle Exterior _061162 LIGHTING (EXT) _0406613 HEADLIGHT ASSEMBLY(for Single Beam Headlight) A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY(for Single Beam Headlight)  REPAIR  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.

·

If the installation area of the headlight assembly is damaged, use a supply retainer for a low-cost repair.

·

Ensure that the headlight assembly is not damaged.



PROCEDURE

Hide 81193C 1.INSTALL UPPER HEADLIGHT PROTECTOR RETAINER

a.
E351129

Cut off the blue-colored part in the illustration and sand smooth with sandpaper.

HINT:

After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.



b.
E351130

Install the upper headlight protector retainer with the screw.


Hide 81193B 2.INSTALL UPPER NO. 2 HEADLIGHT PROTECTOR RETAINER

a.
E426120

Cut off the blue-colored part in the illustration and sand smooth with sandpaper.

HINT:

After cutting off the part, place the upper No. 2 headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.



b.
E431548

Install the upper No. 2 headlight protector retainer with the 2 screws.


Hide 81193E 3.INSTALL UPPER NO. 3 HEADLIGHT PROTECTOR RETAINER

a.
E426122

Cut off the blue-colored part in the illustration and sand smooth with sandpaper.

HINT:

After cutting off the part, place the lower headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.



b.

for Type A:

i.
E431549

Cut off the blue-colored part in the illustration of the upper No. 3 headlight protector retainer.


ii.
E431550

Install the upper No. 3 headlight protector retainer with the 2 screws.



c.

for Type B:

i.
E438657

Install the upper No. 3 headlight protector retainer with the 2 screws.